Power supply, smart way to control your house
For BUS/SCS
- Secure power supply
- 230 V~ – 27 VDC – 1.2 A
- 17.5 mm 8 modules DIN
Must be used to supply power to the MY HOME and Lighting Management systems. On the output, the unit supplies a 27 Vdc continuous low voltage, with a maximum current of 1 A. It is electronically protected (without fuses) against
short circuit and overload.
It’s a double insulation safety device in accordance with CEI EN60065, and can therefore be used in conjunction with a SELV source.
This unit is fitted inside a 8 DIN rail module enclosure, and its installation must be in accordance with the regulations of the country of use.
In general, the following requirements must be met:
- The device must always be installed in appropriate enclosures.
- The device must be kept away from water drips and sprays.
- Care must be taken not to obstruct the air vents.
- A two-pole circuit breaker must be installed, with contact separation of at least 3 mm located nearby the power supply. The circuit breaker is used to disconnect the power supply from the mains, and to protect it.